Outputs from PRM tasks solved by CAI

• task no. VII/5/09 Processing of documents for the ongoing unification of assessments of accredited pressure calibration laboratories - final report

• task no. VII/5/10 Processing of documents for the ongoing unification of assessments of accredited calibration laboratories in the field of temperature - final report

• task no. VII/5/11 Preparation of documents for the ongoing unification of procedures of accredited calibration laboratories in the field of electrical quantities - final report

• task no. VII/4/12 Preparation of documents for the ongoing unification of procedures of accredited calibration laboratories in the field of geometric quantities - final report, annex 2, annex 3, annex 4, annex 5, annex 6, annex 7, annex 8

• task no. VII/5/12 Preparation of documents for the ongoing unification of procedures of accredited calibration laboratories in the field of electrical quantities - final report

• task no. VII/4/13 Optimization of the use of MPZ in accredited calibration laboratories - final report, MPA change sheet

• task no. VII/5/13 Introduction of the “Accreditation of Reference Material Producers” service into the accreditation system of the Czech Republic - final report, Annex 2 – methodology, instructions 1, instructions 2

• task no. VII/4/14 Optimizing the use of interlaboratory comparisons and proficiency testing in accredited calibration laboratories (AKL) - final report

• task no. VII/5/14 Preparation and use of “in-house” reference materials for quality control in laboratories - final report (PDF 401 kB), note: own translation of ISO Guide 80 was published as TNI (2015)

• task no. VII/5/15 Good practice in using reference materials and related terms and definitions - final report, note.: own translations of ISO Guide 33 and 30 were published as TNI (2016)

• task no. VII/5/16 Reference materials: guidance for characterizing and assessing material homogeneity and stability, translation ISO Guide 35

• task no. VII/5/17 Basis for continuous unification of CMC calculation in accredited laboratories in the field of temperature - final report, appendix

• task VII/4/18 Basis for continuous unification of CMC calculation in accredited laboratories in the field of volume - final report

• task VII/5/18 Basis for continuous unification of CMC calculation in accredited laboratories in the field of pressure - final report

• task VII/5/19 Basis for continuous unification of CMC calculation in accredited calibration laboratories in the field of length - final report

• task VII/5/20 Principles of calibration in the field of basic electrical quantities -  final report, appendix

• task VII/5/21 Principles of calibration in the field of pressure -  final report

• task VII/5/22 Principles of calibration in the field of length and angle - final report, attachment

• task VII/5/23 Unification of uncertainty calculation and calibration principles at POA accredited calibration laboratories in the field of mass - final report, appendix

• task VII/5/24 Aspects of calibration of air humidity meters and their interpretation in the form of a certificate annex
  about accreditation – final report (1-40), (41-80) and (81-119)

• task VII/5/25 Principles of calibration and other aspects of calibration in the fields of mechanical motion, vibration and acoustics - final report, annex 1, Annex 2 (1-16), (17-32), (33-48) and (49-62)